Results 1 to 4 of 4
Thread: Galaxy 6600GE
Hybrid View
-
7th August 2007 23:29 #1
Join Date: May:2006
Location:
Posts: 53
Galaxy 6600GE
. , ! 1 , max (DFI LP SLI-D) , . , . M$ , . :
- - - , .
2- PCI-E - 0
. . - . .
, .
, . .
. , , . , .
-
9th August 2007 17:46 #2Banned
Join Date: Jul:2006
Location:
Posts: 676
?
, .
-
10th August 2007 14:58 #3
Join Date: May:2006
Location:
Posts: 53

- .
This issue might occur if the display driver is caught in an infinite loop while it waits for the video hardware to become idle. This issue typically indicates a problem with the video hardware or that the display driver cannot program the hardware correctly.
-
10th August 2007 18:01 #4Banned
Join Date: Jul:2006
Location:
Posts: 676
,
,
"SYMPTOMS
You may receive one of the following Stop error messages:
STOP 0x000000EA THREAD_STUCK_IN_DEVICE_DRIVER
STOP: 0x100000EA THREAD_STUCK_IN_DEVICE_DRIVER_M
Back to the top
CAUSE
This issue might occur if the display driver is caught in an infinite loop while it waits for the video hardware to become idle. This issue typically indicates a problem with the video hardware or that the display driver cannot program the hardware correctly.
Back to the top
RESOLUTION
To resolve this issue, obtain and install the most current driver for your video adapter, or replace your video card.
Back to the top
WORKAROUND
To work around this issue, follow these steps: 1. Click Start, click Control Panel, and then double-click Display.
2. On the Settings tab, click Advanced, and then click the Troubleshoot tab.
3. Move the Hardware Acceleration slider to None, and then click to clear the Enable Write Combining check box.
4. Click OK, and then click OK.
Note This procedure prevents the display driver from programming the hardware incorrectly, but you may lose some display functionality and performance. Although you can increase the hardware acceleration settings higher than None to regain functionality and performance, these settings increase the chance that the issue will occur again. For maximum stability, leave hardware acceleration off.
Back to the top
MORE INFORMATION
The Stop error message may also occur in video adapter drivers that do not represent a physical device. For example, this Stop error message may occur in the virtual video adapter driver that is used by Symantec PCAnywhere. If PCAnywhere is installed on a computer where this error message occurs, visit the Symantec Web site to determine if there are any available fixes for your version of PCAnywhere.
The third-party products that this article discusses are manufactured by companies that are independent of Microsoft. Microsoft makes no warranty, implied or otherwise, regarding the performance or reliability of these products."
. .
.
.
.




Reply With Quote
, ...
5th May 2023, 14:20 in