Results 1 to 1 of 1
Thread: -
Hybrid View
-
8th July 2010 14:00 #1Registered User
Join Date: Jun:2010
Location: Dobrich
Posts: 1
-
! . DSC LC100PI Digital I/0 NI 6501 : http://sine.ni.com/ds/app/doc/p/id/ds-135/lang/en :
DETECTOR INSTALLATION
Terminal block connections (Fig.6)
Terminals 1 & 2 - Marked T2 and T1 (TAMPER) If a Tamper function is required connect these terminals to a 24-hour normally closed
protective zone in the control unit. If the front cover of the detector is opened, an immediate alarm signal will be sent to the control unit.
Terminals 3 & 4 - Marked NC and C (RELAY ) These are the output relay contacts of the detector. Connect to a normally closed zone in
the control panel.
Terminal 5 - Marked EOL End of line option.
Terminal 6 - Marked - (GND) Connect to the negative Voltage output or ground of the control panel.
Terminal 7 - Marked + (+12V) Connect to a positive Voltage output of 8.2 -16Vdc source (usually from the alarm control unit).
TECHNICAL SPECIFICATION
Model LC-100PI
Detection Method Quad (Four element) PIR
Power Input 8.2 to 16 VDC
Current Draw Standby: 8mA ( 5%)Active: 10mA ( 5%)
Temp.
Compensation YES
Alarm Period 2 sec ( 0.5sec)
Alarm Output N.C 28VDC 0.1 A with 27Ohm series
protection resistor
Tamper Switch N.C 28VDC 0.1A with 10 Ohm series protection
resistor - open when cover is removed
Warm Up Period 60sec ( 5sec)
LED Indicator LED is ON during alarm
RFI Protection 30V/m 10 - 1000MHz
EMI Protection 50,000V of electrical interference from lightning
or power through
Dimensions 92mm x 62.5mm x 40mm(3.62 x 2.46 x 1.57)
Weight 40gr (1.4oz)
!




Reply With Quote
windwos 10
5th May 2023, 00:01 in Windows