Results 1 to 6 of 6
Thread: power bank
Hybrid View
-
19th April 2020 16:58 #1Registered User
Join Date: Dec:2016
Location: Bulgaria
Posts: 17
power bank
power bank ANKER PowerCore II 10000 mA
input: 5V/2A 9V/2A (18W)
output: 5v/3a 9V/2A 12V/1.5A (18W)
a - 12V, 400mA, 14.4W/m ( 15-20)
, . 5V. , ( , .)
, ,
- , - , ? , ?
.
Last edited by Diam0nD; 19th April 2020 at 16:59. Reason:
-
20th April 2020 12:41 #2Registered User
Join Date: May:2017
Location:
Posts: 106
( ), 12 , 5 . ( - ), . .
Xeon E5-2673v4@2,30GHz/32GBDDR4,EIZO S2433w,HP LP2465; Vu +UNO4KSE, Vu+Solo2, Octagon SF8008, DM500, GM 9060, Pacostar TS1262
-
20th April 2020 13:02 #3Registered User
Join Date: Aug:2004
Location: Sofia
Posts: 213
5V, - - , "" .
-
21st April 2020 10:06 #4
Step Up Booster Module ( https://www.aliexpress.com/item/33014407148.html https://www.aliexpress.com/item/4000109380893.html) . step up boost converter, 18650 . .... 400 800 1000 .
-
27th April 2020 11:56 #5
LED 5 , .
FX8300 4ghz Swiftech Apogee ASUS M5A97LE ASUS GTX680 EK-FC680 GTX DCII CORSAIR CX600 Corsair Vengeance LP 2x4GB DDR3 1600 MHz 3X500gbWD-RE
-
3rd May 2020 16:29 #6
, 12V - .
, .
?
Edit: :
Its easy to set a QC3 supply to 12V with just two resistors and a toggle or push button switch. Heres how: Take a 10K Ohm and a 2.2K Ohm and solder in series across the Vbus (red) to ground(black wire). The tap between the two resistors will measure about a Volt. Solder D+ (green to this tap. Then wire the D- (white) through a N.O. switch to the same tap. Apply adapter or power pack supply and wait 1.5 seconds to push the button. Presto, 12V @1.5! No need to hold the button, the supply stays at 12.
. .
- 5V .
12V power bank, barabata.
Edit 2:
5V - .
Last edited by zeox; 3rd May 2020 at 16:47.
:EPOX MF4 Ultra-3#CPU: Athlon 64 X2 4600+ [Xigmatec HDT S963]#RAM: 21GB SuperTalent DDRII 800 CL4
#video:GAINWARD 8800GS 384MB#PSU:COOLER MASTER RP M520#Monitor:HP P1100 1280x1024 @100Hz




Reply With Quote
LOG
6th May 2023, 12:03 in