Results 1 to 5 of 5
Thread: SATA ATA 100 HDD
Hybrid View
-
20th January 2005 19:26 #1
SATA ATA 100 HDD
:
Seagate 160 GB SATA Windows (WD ATA 100) , C D Western-a, Seagate-a E: Windowsa E:
?No comment !
-
20th January 2005 19:56 #2
, SATA .
, , :
http://www.neoseeker.com/Hardware/faqs/kb/15,24.html
-
20th January 2005 20:44 #3, PC- boot ATA , "Insert System disk and press Enter" Enter SATA ?If you are running other ide hard drivers you will want to disable them in the bois frist so that windows wont reconize them during set up because by default windwos set up will want to write the mbr to ide 0 masters. disableing ide 0 will make windows write the mbr on the serail drive. after install is complite renable ide 0.No comment !
-
20th January 2005 20:46 #4After hours of dorking around with a WD1200 - and loading the drivers during Windows setup, I found that I had to enable LBA and ATA in the bios. Make sure you check this.
LBA ,
No comment !
-
21st January 2005 10:38 #5
LBA - Logical Block Addressing
a method used with SCSI and IDE disk drives to translate the cylinder, head, and sector specifications of the drive into addresses that can be used by an enhanced BIOS. LBA is used with drive's that are larger than 504 MB.
http://www.pcguide.com/ref/hdd/bios/modesLBA-c.html
IDE ( BIOS-a ; - IDE ) Windows- SATA . , BIOS-a OS SATA .KT7A-RAID/TB@1350/768MB NCP@150MHz/350W PM/GB 8500(302/292)/Audigy/3COM 905C/120GB
DFI LP NFII UltraB/1800+ @2.5GHz 1.79V/SP-97/1GB BH5&6@228MHz/CM Stacker/460W Fortron/Asus V9980 Ultra (1000/500)/120GB D9




Reply With Quote
windwos 10
5th May 2023, 00:01 in Windows